923760200_09_001
Page 2 of 5
Installation:
It’s recommended that the
GR-7602
Wifi Gateway is positioned at a central point of the entire
wireless emergency lighting installation. At least 2 or 3 luminaires should be inside the signal range
of the Gateway in order to create alternative routes for re-transmitting messages to other devices
inside their own range.
See next schematic 1:
Mounting:
Install the device to a stable and visible position which has access to mains power and Wi-Fi
Network. It is recommended that while fitted, the LED indications are visible to a technician.
Avoid metallic surfaces, as they can affect RF signal strength. Ensure that there is not any severe
RF blocking due to structural design.
Use the 2 mounting holes to fit the base on a vertical wall (concrete/brick/wood) and the embedded
spirit level to make fine (horizontal) adjustments. Tighten the mounting screws when done.
Connect the mains power cables. See Wiring and Dimension schematic in page 4.
Schematic 1: Gateway installation plan
Signal route
Wireless luminaries
Important Note:
In order to ensure a stable Wi-Fi connection, check the reception signal level on the area the
GR-7602 is installed, with the help of a Wi-Fi laptop, smartphone, or a special measuring tool.
It’s recommended, for security reasons, to use WPA/WPA2 security with AES/TKIP encryption.
Consult an IT technician for Wi-Fi network configurations when needed.
This device is powered from the mains, so in case of
mains interruption it will stop working.
If your wireless network needs to be “alive” during this situation, care should be taken so that the
device is powered by a UPS system.
When the front face is removed in order to access the internal button, do not touch any other areas
other than the button. Live voltage is present to specific areas of the device.
