Page
1
from
3
923021042_09_005
TECHNICAL CHARACTERISTICS
220-240V AC/50-60Hz
SUPPLY CURRENT
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (
DJWS12-7.0)
Sealed Lead-Acid 12V/7Ah, 0 ~ 40°C
2 x
Sealed Lead-Acid 12V/7Ah, 0 ~ 40°C
BATTERY PROTECTION
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
GUARANTEE
CHARGING TIME
INDICATIONS - CONTROLS
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
EMERGENCY ILLUMINATION
LIGHT SOURCE
24h
IP42
o
5 to 40 C
Up to 95%
3 years
(1
year for the battery
)
180 min
90 min
3200lm
White LEDs
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
U-OUT
30V
OPEN CIRCUIT VOLTAGE
23.5V DC
75°C at R11
8A/250V FB, 5x20mm
Prated/Irated
Iemergency
WIRE CROSS SECTION
CONTROL GEAR FUSE
CONTROL GEAR MAX. TEMPERATURE
Deep discharge and overcharge protection / the control gear will recharge the battery normally after the test of 22.3
MAX. VOLTAGE IN STANDBY OPERATION
MIN. - MAX.
CHARGE CURRENT / VOLTAGE RANGE
MIN. - MAX.
DISCHARGE CURRENT / VOLTAGE RANGE
230
-
7
1
0 mA / 10.5
-
14.5V
1700
-
23
00 mA / 13.8
-
10.5
CONTROLGEAR MIN/MAX VOLTAGE LOAD OUTPUT
17 / 23V
TYPICAL WEIGHT
MAX. CHARGING VOLTAGE IN NORMAL CYCLE
14.5V
13.8V
2
Power Cables: 0.8-2.5mm
60 °C max. across the board
Cable connection between main pcb and led module
19-23V
4.9W
2002163
Built-in
Basic Insulation
700 V
59
0 mA on each lamp
NON MAINTAINED EMERGENCY LUMINAIRES
GRL-21/H/90
GRL-21/H/180
13.3W/
1
4VA
Aluminium
,
ABS/PC, PC
6
300gr
.
4
10
0
gr
21.6W / 1.2A
590mA per Lamp
2.15A
Power, Battery Charge / TEST Button
63 mA
Rated CURRENT @12V
ELECTRONIC CONTROL GEAR
The controlgear can supply the LED modules only during emergency operation
The controlgear has mains-connected windings of transformer
The controlgear is suitable for LED module only
LED MODULE CHARACTERISTICS
Olympia Electronics S.A
.
Manufacturer
Voltage Range
Connections
Nominal Power
Supply Current
Temperature (tc)
Model Number
Max Working Voltage for Proper Insulation
LV Supply - Control
C
onductors
I
nsulation
T
ype
LED
M
odule Type
The controlgear is proof against supply voltage polarity reversal
The lamp controlgear relies upon the luminaire enclosure for protection against accidental contact with live part (7.2 BS EN 61347-2-7)
302 x 94 x 350 χιλ.
NOTE Maintenance of the declared insulation barrier for the luminaire can also be dependent on other external
components/products connected to the same bus. This is the responsibility of the control system designer, not
the luminaire manufacturer.
