Page
1
from
5
923037016
_09_00
1
SELF-TESTING NON MAINTAINED EMERGENCY LUMINAIRE WITH WIRELESS COMMUNICATION
TECHNICAL CHARACTERISTICS
(
for LED MODULE Specifications see page 5)
220-240V AC/50-60Hz
90 min.
<24 h
POWER-CHARGE indicator, LAMP FAULT–BATT. FAULT indicator, TEST button
From overcharge and deep discharge
IP42
2x12V/7Ah
White Power LEDs
13
.
3W/
14
VA
o
5 to 40 C
Up to 95%
Aluminum, ABS/PC, PC
3 years
(1
year for the battery
)
3200lm
302 x 94 x 350 mm.
6310gr.
Thank you for your trust in our products
Olympia Electronics - European manufacturer
GRL-37/180/WL
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Pb)
CHARGING TIME
INDICATIONS - CONTROLS
BATTERY PROTECTION
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
EMERGENCY ILLUMINATION
LIGHT SOURCE
12V/7Ah
180 min.
4120gr.
GRL-37/90/WL
o
These luminaires are used
(
ta 40 C
)
where
emergency light is needed.
Each luminaire must
be connected permanently to the mains power
supply.
OPERATION DESCRIPTION
GENERAL
When the unit is connected to the mains power
supply (after connecting the battery) the indicator
LAMP FAULT – BATT. FAULT remains OFF
whereas the indicator POWER CHARGE blinks to
indicate that the batteries are charging. When the
batteries are fully charged this indicator will light
permanently. If this indicator does not light then
probably the battery has not been connected. If
the batteries are connected and the indicator does
not light then contact a qualified service technician
for assistance. The charging procedure is
monitored by a microprocessor and is based on a
3 stage cycle thus ensuring a fast and full charge
of the battery. The charge current is supplied by a
high efficiency switch mode power supply which
ensures perfect charging even during the
fluctuations of the mains power supply.
BATTERY CUTOFF
The unit enters this state during the power supply
failure and when the battery has been fully
discharged. In this state the luminaire draws the
least power from the battery in order to prevent
deep discharge.
Is accomplished by briefly (<1 sec.) pressing the
TEST button. This permits the user to test the good
operation of the luminaire’s emergency circuit.
The
unit simulates a power failure and the lamps are lit
using the batteries. This manual test does not affect
the automatic test
.
When the
luminaire is in emergency mode
, with
corresponding press
ing
s of the button, we ca
n
choose
the illumination of 100%, 50%, 33%
or
turned off
, either to increase the autonomy time or
not to consume
the
battery power unnecessarily.
This option is canceled when the network is
restored.
MANUAL TESTING
DIMMING OPTION
TX POWER
TX/RX FREQUENCY RANGE
11dBm
868.150-868.450MHz
EN 60598-1, EN 60598-2-22, EN 55015, EN 61547, EN 61000-3-2,
EN 61000-3-3,
EN 62311, ETSI EN 303 446-1 V1.1.0, ETSI EN 300 220-2 V3.1.1
