923200000_09_003
Page
from
4
4
3
Installation procedure of the luminaire
1
the
to mount the luminaire to a flat wall
stall
Attention
in such a way as to align the power cables
s
for phase
be
powered by the mains power supply
in
In order to install the luminaire you need to insert a flat blade screwdriver in region
, so it
separates the plastic hooks to remove the plastic cover as shown to the picture. Do the same for
the Cover on the other side of the luminaire.
2 Use the support materials contained in
packaging
.
3
. Connect the power
cord to terminal
L
and N for neutral.
4 Re-in
carefully the plastic covers removed in step 1 and the device is ready to
A
Put the battery's jumper slot onto the board as shown
the picture
!!! The luminaire should be placed
with the power supply cable entry of the luminaire
1
A
2
Cable
Entry
L
N
Performed by continuous
pressing
for 10 seconds.
:
Within 5 seconds the
(the 3
quentially) and
.
(
.
Performed by continuous
pressing
for 15
:
Within 5 seconds the
(the 3
quentially),
and
15 seconds the red
orange LED
.
If you release the button immediately
the light sensor is activated or
deactivated, depending on
.
The light sensor when activated, controls the LED lighting
GR-2000 only
operation and not
. When
lighting
the area where the
is sufficient,
the LED lighting
so as not to
e unnecessary energy, as defined
he
guidelines of the European Union. It should therefore be taken
that the installation
of
relative to other light sources
to ensure smooth operation.
ly
the button
The following will occur when
the button is pressed
faults are cleared
indication LEDs light se
at the end
of the 10 seconds the green and red LEDs stay on When these LEDs stay on release the test
button and the luminaire will operate as maintained or non-maintained depending on the
previous mode of operation.
with mains power supply present)
ly
the button
seconds. The following will occur when
the button is pressed
faults are cleared
indication LEDs light se
in 10 seconds
the green and red LEDs light
in
goes OFF and the
lights
after the orange LED lights
the previous state
(only in emergency mode).
By pressing continuously the test button for 5 seconds, the luminaire will light in 30% of the
nominal luminosity. If the test button is pressed again for 5 seconds the luminaire will light again
in 100% of the nominal luminosity.
of the
when it is
connected to the mains power supply
in emergency mode, operating as
maintained luminaire
the
of
luminaire is placed
turns off
consum
by t
into account
the luminaire is
in order
One
simple rule for installation is: keep minimum distance of 0.5m from the ceiling and 1.5 m from
the wall on the test button side.
During the change of operation, from maintained to non-maintained,
the red indication led will blink once. During the change of operation from non-maintained to
maintained the red indication led will blink twice.
When the sensor is deactivated, the orange
indication led will blink once and when is reactivated the orange indication led will blink twice.
-
/
Light sensor
-
LIGHT SENSOR
Activation Deactivation
Light adjustment
