OLYMPIA EXPRESS
MAXIMATIC
PAY CAREFUL ATTENTION TO THE INSTRUCTIONS BEFORE USING THE MACHINE
STARTING PROCEOURE
-
NEVER UNSCREW THE CAP OF THE BOILER 1 WHILE THE MACHINE IS ON OR IF THE STEAM
HAS NOT BEEN FULLY RELEASED FROM THE STEAM SPOUT 12. BEFORE UNSCREWING THE
CAP OF THE BOILER 1 ALWAYS TURN OFF THE MACHINE 4 AND TURN ON THE STEAM KNOB 3
RELEASING ALL THE STEAM FROM THE SPOUT 12.
-
Unscrew the cap of the boiler 1 and pour in water using the funnel d until the water in the
water level indicator 11 reaches the upper arrow. Screw the cap 1 back on firmly. The boiler
has now been correctly 3/4 filled and steam can now be obtained.
-
Lift lid 2 and fill the container with cold water without letting it overflow. This water is used
for making the coffee. Close the lid 2.
-
Plug in the machine and switch on by pressing 4. This switch and the heating control light 5
will light up.
-
Immediately, while the machine is still cold, carry out the following operations;
Put the jug g
under unit 10. Press switch 6. thereby releasing a little water from unit 10. If when you press
switch 6 no water comes out of unit 10, operate the pump several times by pressing switch 6
repeatedly. Be careful never to leave switch 6 on for more than 30 seconds at a time. Release
enough water to fill about 1/4 of the jug, press the coffee switch 6 again and remove the jug g.
-
The heating control light 5 will go on and off at irregular intervals. This shows that the
automatic heating of the water in the boiler is in operation; a pressure gauge controls the heat
according to the pressure in the boiler, thus keeping the water at a constant temperature while
also saving on electricity.
-
Before preparing the first coffee when the machine is used for the first time or after leaving it
switched off for some time (during the night or a period of absence) It is necessary to heat the
mechanical parts. To do this, fix the filter-holder 7 to the unit 10 by turning the handle 9 from
left to right, then place the jug g under the spout 8. Press the switch 6 and let enough water
come out to fill about 1/4 of the jug. Press switch 6 again, remove jug g and the filter-holder 7
from the unit 10.
TO PREPARE AN ESPRESSO COFFEE
- Place the filter (a for one cup, b for two cups) into the filter-holder 7. Fill the filter with ground
coffee using the spoon e and then press the coffee into the filter with the presser c. Fix the
filter-holder 7 to the unit 10.
- Place one or two cups under the spout 8, press the switch 6 and a delicious creamy coffee will
Summary of Contents for EXPRESS MAXIMATIC
Page 1: ......
