12
Press
or
key to search the required number in
the redial memory list.
z
Press key to carry out the conversation.
z
Press key to end the call.
Note:
1. If the number is longer than 12 digits, only the last 12
digits will be shown.
2. Name is displayed instead if number is matched with phone
book memory.
Dialing from the Phone Book
z
Press key; the first entry in the phone book appears.
(Or “MEM EMPTY” if no entry)
z
Press or
key to select the required subscriber
from the phone book. Alternatively, enter the first letter of
the name required.
z
Press key. The number is dialed.
Note: How to store entries in the phone book is explained in the
Chapter “Phone Book”.
Call Log Operations
IMPORTANT:
To use the “Call Log” function, you must
subscribe to your network operator’s Caller Line Identification
(CLI) service.
Browse, Call Back, Delete, Store
If calls have been received in your absence, these are stored in
the CALL LOG memory when your telephone service has
enabled this function. The number of calls appears in the
display.
z
Press key as often as necessary until CALL LOG
menu appears. Then press “OK/INT” key. Alternatively,
press and hold “
*
” key 2 seconds.
13
z
Browse:
Press or
key to browse through the
CALL LOG memory.
Or
z
Call
Back:
press key to call back.
Or
z
Delete: Press and hold “C” key two seconds to delete one
or all the entries. Selection is made by pressing
or
key.
Or
z
Store:
Press key, then press “OK/INT” key to start the
NAME entry by keypad. Press “OK/INT” key to confirm.
Select the ring tone with
or
key. Press “OK/INT”
key when finish.
Note: 1. The CALL LOG icon and display indicator disappear
only after browsing through all the entries.
2. It is only possible to enter subscribers in the phone book who
has not stored before.
Edit Call Log memory
When browsing Call Log memory, Caller Line Identification (CLI)
number can be edited before dial back. Amended CLI number
will not overwrite the stored Call Log memory.
z
Press “OK/INT” key to enter edit mode.
z
Press “0-9” to add digits behind of CLI number.
z
Press “C” key to remove digits.
Muting the Microphone
z
Press key can switch the microphone on or off during
a call.
Holding Calls / Forwarding Calls
If the telephone is connected to a PABX system, it is possible to
put calls on hold and call other extension lines or to forward
calls.
z
Press “R” key to put the call on hold and dial the extension
