Technical Data
Laminator A 235 Plus
21
The lamination result is not as good
as expected - the laminated foil is
not completely transparent or is
wavy, or the laminated material is
damaged.
Use only laminating foils that meet the
requirements in the "Technical Data".
Do not exceed the maximum thickness of
the laminated material and foil.
Laminate the same foil again to improve
the lamination result.
Make sure you do not hot-laminate heat-
sensitive material.
If you use thicker laminating foils
(100 μ or 125 μm), allow the laminator to
warm up longer.
Technical Data
Laminating system:
Hot-roller
Laminating temperature
COLD: Room temperature: max. 35 °C
HOT:
97 - 105 °C
Laminating width (max.)
230 mm
Lamination thickness (max.)
0.5 mm
Warm-up phase
3 - 4 minutes
Foil thickness
80 - 125 micron
Laminating speed:
300 mm/min.
Automatic switch-off
in case of overheating
Yes
Indicator lamps
2, Ready and Power
Cool down phase
approx. 30 min.
Rollers
4
Power supply
220 - 240 V, 50 Hz, 1.15 A
Power consumption
265 W
Dimensions
380 x 160 x 36 mm
Weight
Approx. 1175 g
Suitable materials
(hot lamination)
Non-heat sensitive material up to a total thick
ness of 0.5 mm
Suitable materials
(cold lamination)
Heat sensitive material up to a total thickness
of 0.5 mm
Summary of Contents for A 235 Plus
Page 84: ......
