14
Features
Protection and refinement of your documents.
Laminate photos, documents, graphics, ID cards etc. up to A4/A3 size. The
device operates using 2 heating rollers, has a quick warm-up phase and
laminates without a carrier.
LEDs indicate the operating status
Automatic switch-off in the event of overheating
High quality heating system prevents smudging and blistering
Warm-up phase, approx. 5 minutes
Cool down phase to room temperature, approx. 30 minutes.
Foil thickness, minimum 75
m and maximal 175
m
A 296 Plus
A 396 Plus
Laminating system:
Hot roller technology
Maximum foil thickness:
75 - 175 micron
Laminating speed:
300 mm/min
Power supply:
220 - 240 Volt, 50 Hz
Working width:
230 mm (A4)
330 mm (A3)
Power consumption:
260 W
350 W
Dimensions (LxWxH):
340 x 159 x 70 mm
434 x 159 x 70 mm
Weight:
Approx. 1.25 kg
Approx. 1.6 kg
Hot Lamination
1
Connect the power cable to an easily accessible, properly installed
power socket.
Attention:
Check that the voltage specifications of the machine cor-
respond to that of your power supply network (220 - 240 V, 50 Hz).
2
Switch on the On/Off switch on the right-hand side of the unit (
I)
. The
"COLD"
LED lights up and the drive motor for the transport rollers
starts up.
3
Press the foil thickness switch on the device until the LED (75 mic,
125 mic or 175 mic) corresponding to the foil pocket thickness to be
used flashes.
4
The correct operating temperature is reached after about 5 minutes or
as soon as the foil thickness indicator LED lights up continuously.
5
Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Attention:
Only use hot laminating foils.
