4.4 Adjustment Procedure
4.4.1 Carrier Home Position Adjustment
Check:
While in adjustment mode, press the return key and make sure that
the beeper does not sound when the typewriter checks the carrier
home position.
Adjustment: 1)
After
turning the power switch off, move the left edge of the rail
slide (1) close to the right marking on the front guide rail
markings (2-A).
2) Enter adjustment mode. (Refer to 4.3.1 "Carrier Home Position
Adjustment Mode".)
3) Press the space bar, back space key, relocation key, and tab
set/clear key to move the carrier so that the left edge of the rail
slide (1) is as close as possible to the right marking on the front
guide rail markings (2-A).
4) Press the express key to activate the carrier motor.
5) Set the carrier to the position just before the left end switch is
turned off:
If the beeper is sounding, loosen the adjustment screw (2-B)
until the beeper stops.
If the beeper is not sounding, tighten the adjustment screw (2-B)
up to the position where the beeper starts sounding. Finally, fix
the screw's position with the locking nut (2-C).
Confirmation:
Press the return key to confirm the carrier home position. The
carrier home position is set correctly if the beeper does not sound.
If the beeper sounds intermittently, return to step 3 of the
adjustment procedure.
Possible symptoms:
The margin scale and the starting printing position do not match.
4-3
Summary of Contents for Carrera De Luxe MD
