Quick Reference
CM 1830 Cash Register
5/621/3300 (13)
Olympia 09.2001
Page 10
All rights reserved.
Error messages: operation
Error messages appear in the display and an acoustic signal is issued as a result of incorrect operation.
6
Error message is cleared
Error
message
Cause
E00
Incorrect key pressed
E01
Incorrect key operation sequence
E02
A number/digit sequence (with decimal point) must be
entered or the entry is too long
E03
Result exceeds permitted number of digits or is zero
E04
Result exceeds permitted number of digits or is zero
E10
Incorrect key pressed
E20
Card payments related to negative values are not
accepted
E24
Electronic cash-card used for payment not recognized
E30
This operation must be performed within a registration
E31
This operation must be performed outside a registration
E32 (
ÁÇÅÅ
)
PLU number in the registration outside the range
E33
PLU in the registration could not be found
E40
The operation requires the input of a number
E41
The operation does not require the input of a number
E42
The operation accepts the input of a zero
E43
The number entered exceeds the range
E44
The digits entered exceeds the range for PLU input
E45
Result cannot be rounded
E46
Result cannot be rounded
E47
The maximum permissible amount for checks has been
exceeded
E48
The percentage value is outside the range
E50
The operation does not accept the entry of a decimal
point
E51
The decimal point has already been entered
E52
The number of decimal places for percentage input
exceeds 2
Error
message
Cause
E60
The item barcode is valid but not found in the PLU
database.
E61
This item has been withdrawn from sales
E62
This department has been withdrawn from sales
E63
Discount is possible for this PLU registration
E64
The PLU index is outside the range
E65
The number of digits permitted for price entry for
departments has been exceeded
E70
It is not necessary to enter the clerk code
E71
The clerk code entered exceeds four digits
E72
The clerk code is incorrect
E80
The input must be positive or zero
E81
The item barcode was not found / recognized
E82
The result exceeds the range
E83
The sum exceeds the range
E84
The counter for the validation printout exceeds the
permissible value
¿ÊËÂÀ¸ÁÇÅÅ
The total amount in the cash register drawer exceeds the
permissible value
E86
Operating mode R/T has been changed
E87
Price input zero has been blocked
E88
Compulsory to enter the change
E89
Pay out amount is greater than the amount in the cash
drawer
E90
º¸ÆÄ
Printer fault (jam)
E91
º¸ÆÁ
Printer memory is full
E92
A fixed key cannot be reprogrammed
Å»½
Clerk code must be entered, up to four digits
ſ½
Language change when entering the language code
Caution!
All settings will be lost!
ϹÉ
Change keyboard assignment
Only enter the following when you are familiar with the programming functions!
Caution:
Set the key to position P
After pressing the following key combination, the daily sales, grand total and all programmed settings
(departments, PLUs, Flags etc.) are deleted.
k
¿Å¹Ê¸
appears in the display
y
All programmed settings and sales figures are deleted
After pressing the following key combination, all the programmed settings (departments, PLUs, etc.) are
deleted and reset to their "default state".
U
À¹ÁÊÇż
appears in the display
y
The department and PLU prices are reset
After pressing the following key combination, the grand total is reset. It is only executed when the
Full Z-report and Monthly Report were printed out beforehand.
s
¿Å¹Ê¸
appears in the display
y
The grand total is deleted
