25
11 Troubleshooting
Problem Diagnosis
&
Cause Solution
Is the power plug connected
properly in the power socket?
Connect the power plug to the
power socket properly.
Is the On/Off switch set to
OFF
?
Set the On/Off switch to its
ON
position.
Is the
ECS
function activated?
Press the
ECS
button so that it
lights up blue.
Has the device been
assembled properly?
Ensure that the waste bin has
been inserted properly.
Device does not
work
Does the motor fail to start
when material is fed in?
Slide the material in the
respective infeed slot so that it
makes contact with the sensor
in the middle.
Device no longer
functions after a
longer period out
of service or
stops during
operation
Was the device shutdown for a
longer time? Is the surface of
the device warm? The
permissible operating cycle
has probably been exceeded.
First of all, disconnect the
power plug from the power
socket and allow the motor to
cool down to room temperature.
For information on the operating
cycle, refer to Chapter
"Technical Data".
Overloading
(material jam)
Have you exceeded the
permissible material capacity
(refer to Chapter "Technical
Data")? Has the material been
fed in askew?
Clear the material jam, refer to
Chapter "Clearing a material
jam".
Note:
If you cannot clear the fault yourself, contact your dealer or call the
Olympia hotline.
