Important: Sequence of Installation:
Installing the driver for the USB-to-serial adapter
The USB-to-serial adapter is normally supplied with a driver CD. Only install the driver for the USB-to-serial
adapter to begin with. Then connect the USB-to-serial adapter. A message indicating successful installation
of the new hardware should appear when the installation routine has finished. In order to control that the
driver has been installed, open Control Panel, File Manager, Connections (COM and LPT) to view the
adapter. Click with the right-hand mouse button on this entry and open the properties. It should indicate that
the device is ready to operate.
Downloading the necessary files from the Olympia homepage
The Olympia homepage
www.olympia-vertrieb.de
contains the required files in the Firmware Update path
under the bank note validators NC 320, NC 330 and NC 340. You must then download these files on your PC
in a new path. You can then find the
stc-isp-15xx-v6.21
programme and the three programme code files.
Opening the programme
Connect the USB-to-serial adapter. Connect the adapter to the bank note validator using the null modem
cable. Please pay attention that the bank note validator
is not switched on
. Open the
stc-isp-15xx-v6.21
programme. The following screen appears:
