OL3020 User Manual
13
blinking of the Base Unit’s ‘
In
Use/Charge
’ LED. The Handset’s ‘
New Call
’
LED also blinks during ringing.
2.
When the Handset is in the cradle, simply pick it up to talk. It will automatically
answer the call. The ‘TALK’ button will be disabled for 5 seconds. This is the
Auto Answer
feature.
3.
When the Handset is away from the Base Unit, press the ‘
TALK
’ button on the
Handset. You can also press any number key
0-9
,
*
or
#
to answer the call. This
is the
Any Key Answer
feature. The ‘
In Use / Charge
’ LED turns on after the
connection is successful.
4.
If the communication link cannot be established within
8 seconds
, three error
beeps will be heard from the Handset to indicate communication has failed.
9
Make a Call
1. Each new call must begin by pressing the ‘
TALK
’ button on the Handset. It will
scan for a clear channel of communication. At the same time, ‘TALK’ will be
shown on LCD display.
2. If the communication link is not established within
8 seconds
, there error beeps
will be heard from the Handset to indicate communication has failed.
3. You can dial the phone number first, then press
TALK
(this is called
pre-dial
); or
press
TALK
first, then dial.
10 Terminate a Call
1. To terminate a call, press the ‘
TALK
’ button;
-
OR
-
2. Place the Handset in the cradle; the call is then terminated.
3. Your Handset will emit an error beep if it cannot receive an acknowledgement
from the Base Unit. In this case, put the Handset back in the cradle to make sure
the call has been terminated.
11 Short Paging (To Locate the Handset)
1. Press the ‘
PAGE’
key on the base unit. ‘PAGING’ will be shown on the LCD
display and the Handset will emit 3 short beeps, followed by a 1-second pause,
then 3 short beeps.
12 Long Paging
1. Press and hold down the ‘
PAGE’
key on the Base Unit. ‘PAGING’ will be shown
on the LCD display and your Handset will beep. If you hold the button for 5
seconds, the page will be extended to 60 seconds.
2. Press any key on the Handset to stop paging.