Clearing a jam
If too much material is inserted in the respective cutting unit, it will cause a jam.
Proceed as follows:
-
Push the sliding switch to the REV position.
-
The cutting unit runs backwards and pushes the excess material back.
-
Reduce the quantity and slide the switch to AUTO again. The cutting unit runs
forward again and the residue remaining is shredded.
If the backwards and forwards movement does not remedy the jam, pull out the mains
plug and remove the remaining manually from the cutting unit.
Motor protection
The motor switches off automatically in the event of overloading. Pull out the mains
plug from the socket and allow the motor to cool down to room temperature. Plug the
mains cable back in and then continue operation.
Notes on care and maintenance
Caution:
maintenance work may only be performed when the
mains plug is pulled
out
.
To ensure your shredder enjoys a long working life, we recommend to clear residual
material from the cutting units at regular intervals and apply
special oil for paper
shredders
to the cutting unit. This special oil is available from specialist dealers or di-rectly
from our service centre in Hattingen. This will extend the service life of the device.
Technical data
Model:
PS 24 CCD
Cutting width of the paper slot: 220 mm, size of the cuttings: 4 x 45 mm
Cutting width of the CD slot: 123 mm, width of cut strips: 22 mm
Cutting power:
7 DIN A4 sheets (70 g/m
2
), 1 CD, 1 credit card
Security level:
3
Power supply:
AC 220 - 240V / 50Hz
Max. power consumption:
1,2 A
Rated operation: 2 min. on, 20 min. off
Size (W x H x D):
342 x 138 x 380 mm
Weight:
11,3
kg
Paper basket:
12 litre
CD basket:
0,6 litre
Device malfunctions
Problem Cause
Remedy
Is the mains cable plugged
properly in the socket?
Plug the mains cable into the
socket properly.
Is the sliding switch set to
AUTO?
Set the sliding switch to AUTO.
Device does not
work
Does the motor not start
when paper, CD or credit
card is inserted?
Slide the paper, CD or credit card
in the respective slot so that it
touches the sensor in the centre.
Device does not
work after lengthy
operation or
stops during
operation
Was the device in constant
operation for some time?
Is the surface of the device
warm?
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Jam
Have you inserted more
than 7 sheets of paper (70
g/m²), more than 1 CD or
more than 1 credit card?
Has the material not been
inserted straight in the in-
feed slot?
Set the sliding switch to REV to
push back the material. Switch the
device to AUTO again to shred the
material remaining in the cutting
unit.
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.
Disposal Notes
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities. Contact your local government for information regarding the
collection systems available. If electrical appliances are disposed of in landfills or
dumps, hazardous substances can leak into the groundwater and get into the food
chain, damaging your health and well-being. When replacing old appliances with new
once, the retailer is legally obligated to take back your old appliance for disposal at
least for free of charge.