OLYMPIC BILI-BASSINET
Instruction Manual
8-3
Electromagnetic Specifications – Manufacturer’s Declaration
Electromagnetic Specifications –
Manufacturer’s Declaration
The Olympic Bili-Bassinet is intended for use in the electromagnetic environment specified below.
The customer or the user of the Bili-Bassinet should assure that it is used in such an environment.
.
Table 8.1
Electromagnetic emissions
Emissions Test
Compliance
Electromagnetic Environment — Guidance
Radio Frequency (RF)
Emissions
CISPR 11
Group 1
The Bili-Bassinet uses RF energy only for its internal function. Therefore,
its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The Bili-Lite is suitable for use in all establishments other than domestic
and those directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Not applicable
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Not applicable
Table 8.2
Electromagnetic immunity
Immunity Test
IEC 60601
Test Level
Compliance Level
Electromagnetic Environment — Guidance
Electrostatic
Discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±6 kV contact
±8 kV air
Floors should be wood, concrete, or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
±2 kV for power
supply lines
±1 kV for
input/output lines
±2 kV for power
supply lines
±1 kV for
input/output lines
Mains power quality should be that of a typical
commercial or hospital environment.
Surge
IEC 61000-4-5
±1 kV differential
mode
±2 kV common
mode
±1 kV differential
mode
±2 kV common
mode
Mains power quality should be that of a typical
commercial or hospital environment.
Voltage dips, short
interruptions, and
voltage variations
on power supply
input lines
IEC 61000-4-11
<5%
U
T
(>95% dip
in
U
T
) for 0.5 cycle
40%
U
T
(60% dip in
U
T
) for 5 cycles
70%
U
T
(30% dip in
U
T
) for 25 cycles
<5%
U
T
(>95% dip
in
U
T
) for 5 seconds
<5%
U
T
(>95% dip
in
U
T
) for 0.5 cycle
40%
U
T
(60% dip in
U
T
) for 5 cycles
70%
U
T
(30% dip in
U
T
) for 25 cycles
<5%
U
T
(>95% dip
in
U
T
) for 5 seconds
Mains power quality should be that of a typical
commercial or hospital environment. If the user of
the Bili-Bassinet requires continued operation
during power mains interruptions, it is
recommended that the Bili-Bassinet be powered
from an uninterruptible power supply or a battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3 A/m
3 A/m
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
NOTE
#
U
T
is the alternating current (ac) mains voltage prior to the application of the test level.
Summary of Contents for BILI-BASSINET 58110
Page 2: ......
Page 4: ......
Page 14: ...1 8 OLYMPIC BILI BASSINET Instruction Manual Irradiance ...
