DMTA-10045-01EN, Rev. E, August 2016
Chapter 5
76
GATE
The
GATE
setting controls the position on the
RF DISPLAY
where the XY flying
dot display is computed. The
GATE
position determines the signal amplitude
and phase on the XY display. To obtain the best results, set the
GATE
to the left of
the first maximum peak on the
RF DISPLAY
, or on its maximum peak. The
AUTO
gate setting will automatically read the value for the maximum signal
position.
To change the
GATE
setting, press the D key, and then rotate the knob to the
desired gate value.
RF DISPLAY
The
RF DISPLAY
setting controls the display and can be set to
RF
or
IMPULSE
mode. (The name “
IMPULSE
” originates from earlier products.) The
IMPULSE
display uses an envelope filter that is applied over the RF filter.
To change the
RF DISPLAY
setting, press the E key, and then rotate the knob to
the desired value.
CYCLES
The
CYCLES
setting is used to control the number of cycles of the signal in the
tone burst in the PC
RF
and
IMPULSE
display modes, and is adjustable between
1
and
10
.
To change the
CYCLES
setting, press the MAIN menu key (
) followed by
the A key, and then rotate the knob to the desired number of cycles.
H/V GAIN
(horizontal/vertical gain)
The
H/V GAIN
setting applies to display modes (RUNs) that use the XY display.
This parameter allows separate control of the horizontal and vertical gain on the
XY display.
To change the
H/V GAIN
, press the MAIN menu key (
) once or twice
(depending on the RUN selected), followed by the B key, and then rotate the knob
to the desired value.
H GAIN
(horizontal gain)
The
H GAIN
setting controls the horizontal (X) gain, and applies to RUNs using
an XY display.
To change the
H GAIN
, press the MAIN menu key (
) once or twice
(depending on the RUN selected), followed by the C key, and then rotate the knob
to the desired value.
Summary of Contents for BondMaster 600
