DMTA-10045-01EN, Rev. E, August 2016
Chapter 5
86
Figure 5
‑
8 The RUN setting
CURSOR
The
CURSOR
setting controls whether a dot or box is displayed in the flying dot
display.
To change the
CURSOR
setting, press the C key, and then rotate the knob to the
desired cursor value.
GRID
The
GRID
setting controls the condition of the BondMaster 600 display grid. Five
screen grid types are available:
OFF
,
10 × 10
,
FINE
,
COARSE
, and
WEB
. By
default, the BondMaster 600 uses a 10 × 10 grid.
To adjust the grid setting, press the D key. With
GRID
highlighted, rotate the
knob to the desired grid value.
OFF
The BondMaster 600 does not display a grid pattern.
10 × 10
A 10 by 10 grid pattern is displayed, with some unusable areas on the left and
right sides of the screen.
FINE
A grid with 13 horizontal (centered) and 10 vertical divisions is displayed.
The grid divisions furthest to the left and right are half the normal width.
Summary of Contents for BondMaster 600
