ASSEMBLY
/ Removal of transportation lock
II.
DSU
II .
8 - 5
Page
8-4 Removal of transportation lock
This work should be done before connecting
cable of disk box.
1. Loosen screws (2) (2 places) located on top of disk box to
fasten at front side of access panel to microscope frame and
detach the access panel (1).
2. Loosen fixing screw from hole (3) located at left side of disk
box and pull the disk unit (4) upward.
Pull up the disk unit carefully so as not to hit it
inside wall of disk box.
3. Loosen knobs (5) (2 places) of disk unit and open disk cover
(6).
4. Loosen transportation lock knob (7) and remove it from disk
unit (4). Attach the transportation lock knob you just removed
to threaded hole (8) of the disk unit.
Keep transportation lock knob with care as it
may be used for transportation again.
When you continue to install disk, see 8-13 Disk installation
and change.
5. Return disk cover (6) to original position and fix it by
tightening disk unit knobs (5) (2 places).
6. Align disk unit (4) with mount dovetail (9) of disk box and
push it from top to dead end.
7.
Tighten fixing screw (3), using the Allen screwdriver.
8. Attach access panel (1) on top of disk box and tighten fixing
screws (2) (2 places).
Note
Note
Note
(1)
(2)
(3)
(5)
(7)
(6)
(7)
(5)
(8)
(9)
(4)
