ASSEMBLY
/ Installation of illuminator
II.
DSU
II .
8 - 6
Page
8-5 Installation of illuminator
1. Loosen fixing screws (1) (2 places) that fix disk box to microscope
frame, using the Allen screwdriver.
2. Insert illuminator (2) into disk box (3) and push it to the dead end. At
this time, attach it in a way that FS unit faces towards observer.
3.
Tighten fixing screws (1) (2 places), using the Allen screwdriver.
4. Loosen fixing screw (4) of stand and put stand that comes as
accessory underneath the illuminator.
Stand should be attached for sure to prevent upside
down.
5. Extend the stand to apply fixing place to illuminator and tighten fixing
screw (4).
8-6 Installation of lamp house
1. Loosen fixing screws of lamp house mount adapter (1) (2
places), using the Allen screwdriver.
2. Insert lamp house (2) into lamp house mount adapter of light
illuminator (3) and push it to the dead end.
3. Tighten fixing screws (1) (2 places), using the Allen
screwdriver.
Note
(4)
(2)
(3)
(1)
(2)
(3)
(1)
