ASSEMBLY
/ Installation of visual mirror unit (front side)
II.
DSU
II .
8 - 1 1
Page
8-10 Installation of visual mirror unit (front side)
8-10-1 In case of BX
1. Turn turret upside down and loosen fixing screw (1), using dedicated the
Allen screwdriver and remove dummy mirror unit (2) (remove the dummy
mirror unit only where a mirror unit is to be installed from now on).
When mirror units already exist inside the cassette, be
careful so as not to touch dichroic mirror or excitation filter
with your finger.
Reference mirror of adjustment completed is attached at
No.1 position. Do not change the position of this reference
mirror.
2. Insert mirror unit (3) to be used into mount dovetail (4) of mirror unit and
push it until it hits to dead end and then, tighten fixing screw (1), using The
Allen screwdriver.
If the fixing screw (1) is loosened, it may interfere inside
turret cover and turret may not be able to turn. Tighten the
fixing screw even if mirror unit does not exist.
3. Verifying mount dovetail NO (4), insert identifying plate of mirror unit in
reverse way into the same number of display pocket (5) located at front of
turret.
In case that the identifying pocket for turret is used as
indicator for name of objective lens, it cannot be used as
indicator for mirror unit.
Note
Note
Note
Note
(1)
(3)
(4)
(5)
(2)
