37
BX43
Fig. 52
Fig. 53
11
Attaching the AC Adapter
·
Cables and cords are vulnerable when bent or twisted. Never
subject them to excessive force.
·
Make sure that the main switch is set to “ ” (OFF) before
connecting the power cord (Fig. 52).
1. Insert the connector @ of the AC adapter firmly into the connector
2
on
the microscope.
Always use the designated AC adapter. Using a non-designated
AC adapter may cause malfunction.
12
Attaching the Power Cord
Always use the power cord provided by Olympus. If no power
cord is provided with the microscope, please select the proper
power cord by referring to section “PROPER SELECTION OF THE
POWER SUPPLY CORD” at the end of this instruction manual.
Fig. 54
Fig. 55
4
3
Operation Using the AC Adapter (Fig. 53)
1. Insert the connector @ of the power cord firmly into the input connector
2
of the AC adapter (Fig. 53).
The power cord should be connected to a grounded/earthed,
3-conductor power outlet. If the power outlet is not grounded/
earthed properly, Olympus can no longer warrant the electrical
safety performance of the equipment.
2. Plug the power cord plug
3
into the wall outlet | (Fig. 55).
Should the power cord come in contact with the hot lamp socket,
the power cord could melt and cause electric shock. Be sure
to route the power cord away from the lamp socket.
Operation Using the TL4 Power Supply Unit (Fig. 54)
} The following operation is not required when the LED lamp is used.
1. Insert the connector @ of the power cord firmly into the input connector
2
of the TL4 (Fig. 54).
2. Plug the power cord plug
3
into the wall outlet | (Fig. 55).
1
2
1
2
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
1
2
