102
8
Attaching the observation tube
Loosen the observation tube clamping screw of the observation tube
attaching portion using the Allen screwdriver.
Fit the circular dovetail of the observation tube into the observation
tube attaching portion so that the scale numbers of the interpupillary
distance displayed on the observation tube face to the front.
Tighten the observation tube clamping screw to secure the observation
tube.
1
2
3
This picture shows the procedure to attach the
trinocular tube (U-TR30-2). The same procedure
applies when attaching other observation tubes.
3
1
2
9
Attaching the eyepiece
b
a
Insert the eyepiece until it touches the eyepiece sleeve.
·
When using the eyepiece equipped with the micrometer,
insert the eyepiece into the right eyepiece sleeve.
In this case, attach the eyepiece so that the eyepiece positioning
pin
a
enters the groove
b
below the eyepiece sleeve.
·
The super widefield observation tube is equipped with
positioning grooves on both eyepiece sleeves. Be sure to
attach the eyepieces by aligning both eyepiece positioning
pins with the grooves.
1
NOTE
1
7
Attaching the reflected light illuminator
Use the dedicated Allen wrench (
) provided with the reflected
light illuminator to attach the reflected light illuminator.
Without aligning the mounting screws a (4 positions) of the reflected light
illuminator with the mounting screw holes b of the microscope frame
at first, place the reflected light illuminator on the slightly front position.
Then, push the reflected light illuminator backward to the end. This is
the correct attaching position.
While pushing the reflected light illuminator backward to the end,
tighten the mounting screws a (4 positions) using the dedicated
Allen wrench to secure the illuminator.
Attach the caps (4 positions) of the mounting screws provided with
the reflected light illuminator to the a position.
The cable comes out from the back of the coded reflected
light illuminator (BX3M-RLAS-S, BX3M-URAS-S). Be careful
not to put the cable between the illuminator and the
microscope frame.
Use the tweezers, etc when removing the caps of the screws
attached to the reflected light illuminator.
1
2
3
4
NOTE
TIP
a
b
This picture shows the procedure to attach
BX3M-RLAS-S. The same procedure applies when
attaching other reflected light illuminators.
This picture shows the procedure to attach the
reflected light illuminator to the microscope frame.
The same procedure applies when attaching it to
the height adapter.
Summary of Contents for BX53M
Page 51: ...45 BX53M MEMO...
Page 79: ...73 BX53M...
