103
BX53M
Attaching the eyepiece micrometer
The eyepiece micrometer can be attached to WHN10x-H.
Purchase the micrometer with the size Ø24 mm and thickness 1.5 mm.
Remove the built-in micrometer frame from the eyepiece by rotating
it in the arrow direction.
Depending on the case, the micrometer frame may be tightened too
firmly and it cannot be rotated. If you grab the micrometer frame too
firmly, it will be deformed and cannot be turned furthermore. Grab
around the micrometer frame lightly with the equal force to turn it or
push it to the rubber sheet placed on the desk and turn to remove it.
· Insert the micrometer into the micrometer frame with the display surface
of the micrometer facing down.
· Put the micrometer frame back to the eyepiece.
·
Be careful not to touch the lens with your fingers during
working.
·
Do not tighten the micrometer frame with excessive force.
1
TIP
2
3
NOTE
1
2
10
Attaching the objective
Attach the objectives by screwing them into the nosepiece mounting
holes.
1
1
When the motorized or coded nosepiece and
the hand switch are combined
Attach the magnet sheet corresponding to the objectives attached
in
1
to the OB indicator display pocket a of the hand switch
(BX3M-HS).
The magnet sheet is provided with the hand switch (BX3M-HS).
a
Summary of Contents for BX53M
Page 51: ...45 BX53M MEMO...
Page 79: ...73 BX53M...
