DP74
7
3. Do not install the following boards in the adjacent slot on the fan side of the PCIe interface board. Otherwise, it may
deteriorate product performance.
·
Graphic board
·
PCIe interface board of DP80, DP73 or DP72
·
Board with power consumption of 3 W or more
4. When handling the PCIe interface board, be sure to hold it by the edge. Do not allow your fingers to touch the
board surface directly. Otherwise, a failure will be caused.
5. Be sure to install this product not to cover the air vents on the PC.
6. For handling of the PC, refer to the instruction manual provided separately.
7. As the camera head or the PC is heavy, hold it carefully not to drop when attaching or storing.
8. This camera head needs to be calibrated periodically (approx. every 3 months) for the level variations caused by the
influence of cosmic rays. Use cellSens or DP2-TWAIN for calibration. After calibration, restart the system.
9. Do not disconnect the camera cable while the software is running. The product may be damaged.
10. The cables are vulnerable to bend or twist. Do not apply excessive force. When connecting cables, make sure of
the orientation to insert them.
11. If cables are not connected correctly, the product may be damaged. Make sure that the cables are connected to
respective units correctly before operating the product.
12. Note that this product is not waterproof.
13. Never disassemble any part of the product. Otherwise, failure could be caused.
14. Do not use this product in areas where it may be subjected to direct sunlight, high temperature and/or humidity,
dust or vibrations.
(For conditions of operating environments, see "7 Specifications" (page 41.))
15. When disposing of this product, be sure to follow the regulations and rules of your local government.
