3.3 Installation of equipment
29
CLV-190 INSTRUCTION MANUAL
Ch.3
CAUTION
• Do not place any equipment other than the video system center on the top of the
light source. Equipment damage can result.
• Keep the ventilation grills of the light source clear. The ventilation grills are located
on the rear panels. Blockage can cause overheating and equipment damage.
• Clean and vacuum dust the ventilation grills using a vacuum cleaner. Otherwise,
the light source may break down and gets damaged from overheating.
• Place the light source on a stable, level surface using the foot holders (MAJ-1205).
Otherwise, the light source may topple down or drop, and operator or patient injury
may occur, or equipment damage can result.
• When using the mobile workstation, confirm that excessive force is not applied to
the cord of the workstation. The cord may be disconnected, and malfunction can
result.
• If a trolley other than the mobile workstation (WM-NP2, WM-DP2, WM-NP1,
WM-WP1, or WM-DP1) is used, confirm that the trolley can withstand the weight of
the equipment installed on it.
• Do not install the light source in locations exposed to strong electromagnetic
radiation (e.g., in the vicinity of a microwave therapeutic equipment, MRI,
short-wave therapeutic equipment, radio equipment, or cellular/portable phones).
Otherwise, the light source may malfunction.
3.3
Installation of equipment
Summary of Contents for EVIS EXERA III
