26
EN
4
Press the shutter button the rest of the way down to take the picture.
• The AUTO CHECK lamp blinks for about 5 s after shooting to indicate that
the
fl
ash has
fi
red successfully.
• When using a
fl
ash,
fl
ash light may be blocked by the lens body, lens hood, etc.
• The
fl
ash may become hot when
fi
red many times in succession, resulting in
damage or malfunction. The
fl
ash should be
fi
red no more than 50 times in
succession at intervals of 2.5 seconds, after which it should be left unused for
at least 10 minutes.
Test Flash
Test Flash
To
fi
re a test
fl
ash, press the TEST button while the CHARGE lamp is lit. The
AUTO CHECK lamp blinks for about 5 s to indicate that the
fl
ash has
fi
red
successfully. If the lamp does not blink, adjust settings or change the distance to
the subject.
Choosing a Flash Control Mode
Choosing a Flash Control Mode
Choose a
fl
ash control mode according to your subject and shooting conditions.
1
Press the MODE button.
• Settings will be displayed.
2
Rotate the dial to choose a
fl
ash control mode.
Set
Value
OK
DIAL
Gno
40
MODE
M
• The
fl
ash control mode can also be selected by pressing the MODE button.
• Related settings (if displayed) can be highlighted by pressing
HI
and
changed by rotating the dial.
3
Press the OK button to put the changes into effect.
Flash Control Modes
Flash Control Modes
Flash Control
Mode
Control panel
display
Control operation
TTL-AUTO
MODE
LED
ZOOM
TTL
A
mm
25
0.0
OFF
A
RANGE
0.7~8.0
m
The
fl
ash light intensity is controlled
automatically according to the camera’s
setup. The
fl
ash will be adjusted based on
the brightness taken through the camera’s
lens. Usually use this mode with a camera
with communication capability.
Summary of Contents for FL-900R
Page 21: ...21 JP ...
Page 129: ...129 TH ѠѨѯєјҙ LPDJLQJ RWK RO PSXV DS FRP ...
Page 220: ... 2016 WD196202 Printed in China date of issue 2016 07 ...
