APPLIED OPERATIONS
/Saving, Opening and Shredding Images
OPERATION INSTRUCTIONS
2 - 1 1 6
Page
2-3-1 Saving Images
Either a series of images or single image being displayed can be saved.
2-3-1-1 Saving Images As a Series
The displayed images can be saved in a disk as a series image file.
1.
Display the image window showing the image to be saved at the front.
2.
When there is more than one image to be saved, the <Set start position> and <Set end
position> buttons will be displayed on the upper part of the image. Display the image with
which the saving should start using the <Display> buttons, then click the <Set start
position> button.
Also set the save end position in the similar way.
3.
When the images to be saved are acquired from more than one channel, select whether
saving images from more than one channel simultaneously or only a single image from a
single channel.
Use the <Display channel switch> buttons for this selection. The images will be saved
according to the conditions of the selected channels.
Example) When only the image of Channel 1 is displayed, only the image of Channel 1
will be saved.
For the channel switching, see section 2-5-3, “Switching the Displayed
Channels”.
4. Click the <Experiment> button in the [Save] group box. The [Save Experiment As]
dialog box as shown below appears.
Fig. 2-29 [Save Experiment As] Dialog Box
<Set start position> button
<Set stop position> button
<Display> button
<Display channel switch>
buttons
TIP
