APPLIED OPERATIONS
/Protocol processor
OPERATION INSTRUCTIONS
2 - 1 6 3
Page
Command
Entry form
Description
combination. Be careful that other
combination than the following cannot
be entered. (256, 256) (320, 240) (512,
512) (640, 480) (800, 600) (1024, 768)
(1024, 1024) (2048, 2048).
Stop&Save
Stop&Save
Saves all the images acquired before the
Stop&Save command is executed.
Note: The images are saved separately from
the images acquired in succeeding
tracks.
Store
Store
Opens a new image window to display the
image.
Zlock
Zlock [ON/OFF]
It sets Valid/Invalid of Z motor lock. Note that
fine tuning handle and coarse tuning handle
cannot be manually operated when Z motor is
locked. In case that manual operation is
required by releasing Z motor lock, difference
of Z stage position displayed on [Zstage] sub
panel of [Acquire] panel of FV300/500/1000
may occur. Use the handle after confirming
the moving range adequately. In case that Z
stage is controlled with use of command, lock
Z motor. Do not turn fine tuning handle of
microscope in the state that Zlock command is
turned ON as it may cause failure.
<E.g> In case that Z motor lock is required,
enter [Zlock ON].
Zoom
Zoom value
Sets the zoom ratio.
<E.g.> Enter “Zoom 5” to set 5 to the zoom
ratio.
