Getting Started FLUOVIEW/
Outline of LSM Observation Procedures
OPERATION INSTRUCTIONS
1 - 1 0
Page
•
Transmitted
light observation procedure
Set the observation condition.
If no image is
displayed.
Start the system
•
Turn the system power ON.
(Section 1-2-1)
•
Start the FLUOVIEW software.
(Section 1-2-1)
If the i
m
age is still not
displayed
Select the LSM light path.
(Section 1-2-3)
z
Let the transmitted light DIC
slider into the light path.
z
Select the light path for 100%
binocular tube and focus on the
specimen.
(Section 1-2-2)
When the combination using the laser
combiner is used, set the optimum ND
filters for the laser.
(Section 1-2-6)
•
Set the objective magnification.
(Section 1-2-7-1)
•
Set the zoom ratio to 1X.
(Section 1-2-7-2)
•
Set the channels.
(Section 1-2-7-3)
•
Set the highest scan speed.
(Section 1-2-7-4)
•
Select the XY observation mode.
(Section 1-2-7-5)
•
Perform repeated scanning.
(Section 1-2-7-6)
If an image is
displayed
Acquire an image.
(Section 1-2-8)
Save the image.
(Section 1-2-9)
Exit from the FLUOVIEW software.
(Section 1-2-10)
Turn the system power OFF.
(Section 1-2-10)
Image is
displayed in
the [Live]
panel of the
software.
Change the ND filter with a higher
transmittance filter.
(Section 1-2-6)
•
Set the multiple sections to be
observed.
(Section 1-2-7-7)
•
Set the area to be observed.
(Section 1-2-7-8)
•
Set a lower scan speed.
(Section 1-2-7-9)
•
Stop repeated scanning.
(Section 1-2-7-10)
Adjust PMT Voltage.
(Section 2-2-1-4-9)
