APPLIED OPERATIONS
/Building an Image from a Different Viewpoint
OPERATION INSTRUCTIONS
2 - 2 9 7
Page
Among the multiple image slices composing the XYZ image, the range of image slices to be
used in extend image building can be specified.
1. Display the image slice to be set as the start image by using the <Frame advance> or
<Successive display> buttons at the top of the image window.
2. Click the <Set start position> button at the top of the image window.
3. Display the image slice to be set as the end image by using the <Frame advance> or
<Successive display> buttons at the top of the image window.
4. Click the <Set end position> button at the top of the image window.
The <Set start position> and <Set end position> buttons are valid in the
pushed-in condition. To cancel a previously set start or end position, click
the <Set start position> or <Set end position> button again.
When it is required to analyze the built extended-focus image or save it in
the Fluoview Multi Tiff format, create the extended-focus image as a
separate image from the original image. See section 2-8-1-2, “Turning
Built Image into Single Image”.
<Set start position>
button
<Set end position>
button
NOTE
NOTE
