Getting Started FLUOVIEW
/Online Help
OPERATION INSTRUCTIONS
1 - 4 3
Page
z
Clicking the <Link Setting> button displays the [Link Setting] dialog box as shown
below.
Click the desired check box to be checked.
Select the <Close> button to close the dialog box.
The microscope settings are automatically saved and read out when the software is
started up next time.
Checking here links the objective in the [Nosepiece] group box
with the condenser turret.
Checking here escapes the stage or revolving nosepiece when
the objective is selected and changed in the [Nosepiece] group
box.
Checking here disengages the top lens from the light path
when the objective of
×
4 or lower magnification is selected in
the [Nosepiece] group box. (BX only)
Checking here closes the shutter when the Mirror Units are
switched in the [Mirror Unit].
Checking here sets the TD lamp to OFF when the fluorescent
cube is selected in the [Mirror Unit].
Checking here disengages the top lens from the light path
when the fluorescent cube is selected in the [Mirror Unit]. (BX
only)
Checking here enables parfocality correction when the
objective is selected and changed in the [NosePiece] group
box.
<Import Setting> button
Loads the microscope
settings already
registered to reflect it.
<Export
Setting>button
Saves the current
Checking here closes the FL shutter and engages Analyzer and
Polarizer into the light path when the TD lamp is set to ON in
the [Lamp] group box.
When objective is selected in [Nosepiece] group box while this
box is checked, close shutter of incident lighting lamp first and
then, change objective lens. After change, open the shutter.