APPLIED OPERATIONS
/General Operation Procedure
OPERATION INSTRUCTIONS
2 - 4
Page
2-1-2 Image Acquisition Procedure in an Observation Mode (Section (B))
As an example of “Acquire an image in an observation mode”, this section describes the
procedure in the XY observation mode. For the procedures in other observation modes,
see section 2-2-2, “Image Acquisition in Other Observation Modes” as well as the
following procedure.
Set the acquisition parameters.
(Section 2-2-1-4)
z
Observation
mode
z
Scanning
speed
z
Image brightness
Acquire an image in the XY observation mode.
(Section 2-2-1-5)
XY observation
(Section 2-2-1)
Perform accumulation.
(Section 2-2-1-6)
After “Configure the system and confirm the images
to be observed”...
Go to “Save the acquired data in a file.” or “Process the image”.
(B)
z
Multiple-section
to
be
observed
z
Area to be observed
When noise is noticeable:
