57
Fig. 83
Fig. 84
8
Attaching the Eyepieces
(Fig. 83)
1. Remove the eyepieces’ dust caps.
2. Insert the WHN10X-H eyepiece with helicoid into the eyepiece sleeve with-
out helicoid (shown on the left in the figure).
3. Insert the WHN10X eyepiece without helicoid into the eyepiece sleeve
with helicoid (shown on the right in the figure).
Using the Accessory Mounting Holes
(Fig. 84)
}Twelve threaded holes
1
are provided on the microscope frame for mount-
ing accessories such as a micromanipulator.
These holes are covered with plastic dust caps. To remove a cap, insert
the tip of a flat-blade screwdriver sideways into the space between the
cap and the frame.
# The applicable screws are M6 screws. The screws can be inserted
into the microscope frame up to a depth of 10 mm. Select the screw
length in accordance with this.
1
1
