18
19
1
2
3
4
5
1. Keep the
MODE
button pressed
until the “year” indicator starts
blinking.
Be sure to correct the date and time after the batteries have
been inserted or replaced.
2. Press the
SET
button to adjust the
“year” indicator. If you press the
button once, the number on the
display will advance by 1. If you
keep the button pressed, the
numbers will run in rapid
succession. If you pass the
intended number, keep pressing to
return to that number.
3. Press the
MODE
button once more
to make the “month” indicator
blink. Press the
SET
button to
adjust the “month” indicator. As
you press the
MODE
button, the
blinking indicator changes in the
order of “year”, “month”, “day”,
“hour” and “minute”.
4. Repeat Steps 2 and 3 to set “hour”
and “minute”. Make sure the
“minute” indicator is blinking.
5. When “minute” has been set, press
the
MODE
button. None of the
indicators will be blinking and date/
time correction is now complete.
CORRECTING THE DATE AND TIME
(Quartzdate models only)
1
2
3
R
E
M
O
T
E
C
O
N
T
R
O
L
R
C
-3
0
0
C
1. Turn the screw on the bottom of the
remote control counterclockwise to
loosen.
If the selftimer/remote control indicator doesn’t blink even
when you press the button, replace the battery with a new
one (CR2025).
How to replace the battery of the remote control (RC-300C)
2. Turn the remote control over, and
remove the cover. With the battery
facing up, remove the old battery
and insert a new battery as shown.
3. Replace the cover, turn the remote
control over, and turn the screw on
the bottom clockwise to tighten.
RC-300C (Optional)
