DMTA-10040-01EN, Rev. E, February 2018
Chapter 6
310
Commands may be read (R), written (W) or executed (X). Table 7 on page 310 lists the
commands and the format in which they must be written.
3.
In the
Issue Command
dialog box, click
Send
(see Figure 6-18 on page 309).
OR
Press Enter on your PC keyboard.
The NORTEC 600 remote command convention is as follows:
— Read (R) commands end with “?”
Example: AN1?
— Write (W) commands include “=” followed immediately by a value without
any spaces
Example: AN1=45
— Execute (X) commands include only the command
Example: DLB
All commands end with a carriage return and line feed (entered as “\r\n”). Any
space in a Write command should be replaced with an underscore character.
Table 7 NORTEC 600 remote commands
Command
Description
R/W/X
Range/valid strings
Min
Max
ADW
Alarm Dwell
R/W
0.005
10.000
AN1
Angle 1
R/W
0.000
359.900
AN2
Angle 2
R/W
0.000
359.900
ANI
Angle Step Increment
R/W
0.100
ASE
Sweep Erase
R/W
ON/OFF
AST
Auto Sweep Time
R/W
0.005
10.000
NOTE
NOTE
Summary of Contents for nortec 600
