3
- -
2
Insert size-AAA alkaline battery,
observing the correct
=
and
-
polarities.
3
Close the battery cover completely
by pressing to the direction
A
, then
sliding to the direction
B
.
Battery indicator:
When [
] appears on the display, replace the batteries as soon as possible. When the batteries are
too weak, [
s
] and [
Battery Low
] appears on the display and the recorder shuts down.
• Remove the batteries if you are not going to use the recorder for an extended period of time.
• When changing batteries, AAA alkaline batteries or Olympus Ni-MH rechargeable batteries are
recommended.
h
Turning on/off the power
Turning on the power:
While the recorder is turned off, slide the
POWER/HOLD
switch in the direction indicated
by the arrow.
• The display will turn on, and the power will be turned
on.
Turning off the power:
Slide the
POWER/HOLD
switch in the direction
indicated by the arrow for 1 seconds or longer.
• The display shuts off , and the power will be turned
off .
• The resume function remembers the stop position
before the power is turned off .
Power save mode
If the recorder is stopped/not used for over 5 minutes after it is turned on, it goes into standby
(power-save) mode, and the display shuts off.
• To exit standby mode and turn on the display, press any button.
Set the recorder to HOLD mode (
A
):
Slide the
POWER/HOLD
switch to the HOLD
position.
• After [
Hold
] appears on the display, the recorder is set
to HOLD mode.
Exit HOLD mode (
B
):
Slide the
POWER/HOLD
switch to the
C
posi-
tion.
h
HOLD
Notes:
• If you press any button in HOLD mode, the clock display fl ashes for 2 seconds, but it will not
operate the recorder.
• If HOLD is applied during playback (recording), operation is disabled with the playback (recording)
state unchanged (When playback has ended and the recording has ended due to the remaining
memory being used up, it will stop).
C
A
B
h
Setting time and date [Time & Date]
If you set the time and date beforehand, the information when the file is recorded is automatically
stored for each file. Setting the time and date beforehand enables easier file management.
When you install batteries for the first time or each time you replace the batteries, the
“Hour” indication will flash.
