Page 17 of 76
Issue 20 : July 2012
WM--P1 SERIES WORKSTATIONS
6
P
ART
R
EPLACEMENT
6.1
General
The item numbers referred to throughout this Chapter are the same as those used in the Illustrated Parts List, Chapter 6.
To aid part replacement the following are available :
MAJ--198 WN--NP1 Sheft kit (Narrow) -- K10001429
MAJ--199 WN--WP1 Shelf kit (Wide) -- K10001430
Rear panel kit WM--NP1
K10005044
Rear panelkit WM--WP
K10005041
Free castor kit
K10004627
Braked castor kit
K10004626
Castor free kit WM--P1 series A/S
K10005041
Castor braked kit WM--P1 series A/S
K10005040
Castor spanner WM--P1 series
K10005023
Remote switch kit WM--P1 series
K10005049
Umbilical/camera head holder kit
K10006648
Before replacing any part on the workstation ensure that all mains power is disconnected.
Olympus will not be responsible for damage or injury to equipment or personnel, caused by unauthorised modification or
repair to this unit.
In the interests of safety and good maintenance ensure that fixings are tightened to the torque settings shown in the
parts list, illustrated parts list and part replacement chapter.
6.2
Blanking caps & Cable tidy replacement
(1)
Refer to Figure 6-1. Blanking caps: Cable port (item 17), Monitor (item 18) and Scope pole (item 19) are a push fit and
so require to be carefully prised out of position.
(2)
Unscrew Handknob (item 31) to release Cable tidy (item 29).
FIGURE 6-1
BLANKING CAPS & CABLE TIDY
20
21
29
31
17
2
18
2
19
2
47
2
37
2
50
2
67
2
6.3
Bracket twin LG holder replacement
(1)
Refer to Figure 6-1 . and using 4mm hex drive tool bit remove Bracket twin LG holder (item 20) release two screws
(item 37) and washer crinkle (item 50) with washer (item 47) from jetnut (item 67).
(2)
Replace/refit in reverse order. Using 4mm hex drive tool bit in torque driver ensure that screw (item 37) is tightened to a
torque of 6Nm.
