12
1
Power supply
Po
we
r s
u
p
p
ly
Charging by connecting to a
computer via USB
You can charge the batteries by connecting
to a PC's USB port. When charging, be sure
to correctly place the rechargeable batteries
(supplied) into the recorder (
☞
P.10).
1
Boot the PC.
2
Slide the USB connector slide
lever in the direction indicated
by the arrow to eject the USB
connector out of the recorder.
3
While pressing the
STOP
4
button, connect to the PC’s USB
port.
Notes
• The recorder cannot be charged when the
PC is not turned on. Also, it may not be
charged when the PC is in standby mode.
• Do not charge the recorder with the USB
hub connected.
• If [
Cannot charge
] is displayed, it means
that a battery that cannot be charged is
in the recorder. Replace the batteries with
supplied ones at once (
☞
P. 10).
• Charging is completed when battery
indication becomes to [
<
] (charging time:
approximately 3 hours *).
* It shows the approximate time when
charging the rechargeable battery fully
from no remaining power at the room
temperature. The charging time will be
changed depending on the remaining
amount and the state of batteries.
• You cannot charge when [
;
]
*
or [
=
]
**
blinks. Charge the batteries at the
temperature from 5°C to 35°C (41°F to 95°F).
*
[
;
]: When surrounding temperature is
lower than 5°C (41°F).
**
[
=
]: When surrounding temperature is
higher than 35°C (95°F).
• When using time becomes notably short
even after the batteries are fully charged,
replace them with new ones.
• Be sure to push the USB connector all the
way in. Otherwise, the recorder may not
operate properly.
• Use the supplied USB extension cable
depending on situations.
"
For WS-500M: