Description
Installation attention
Dimension
1.
Mainly applicable to small off-grid solar power generation systems, such as: home solar power generation systems,
solar RV power generation, ships, unattended base stations, outposts, etc.
2. System voltage: 12V/24V automatic recognition
3. Can choose a variety of batteries, including lead-acid batteries, lithium ion(NCM), and LiFePO4
4. Adopt three-stage MPPT charging method. Effectively improve the charging efficiency of solar panels.
5. Bluetooth Dongel can be connected extern and various working parameters of the solar controller can be checked
from the mobile phone through a free APP, the communication range is less than 10 meters , (optional function)
6. External solar monitor
6. This product adopts intelligent single chip design, all work processes are controlled by software, which can achieve
high precision and high reliability.
7. The load output can be turned on and off manually by pressing the button
8. Fully automatic control with over-charge, over-discharge, overload protection, anti-reverse connection protection, etc.
solar
charge
controller
Thank you for using our products, please read this
product manual carefully before using the products
NOTE
MPPT5010
MPPT
147
43
6
4
.
5
136.6
9
7
USER
MANUAL
1. The solar cell module will generate electric current under the light. Even in the case of low light, it can generate high voltage.
Before installation, be sure to prepare for the solar power.
Covered by the pool board.
2. Before installing the controller, please confirm whether the voltage on the solar panel and the battery voltage match the controller.
3. During installation, do not touch all bare wires
4. The positive and negative poles of the battery must not be short-circuited. It is recommended to install a fuse in series with the
positive pole when installing the battery.
5. Please do not use inferior raw materials. Such as wire, screws.
6. Maintain the ventilation and heat dissipation effect of the controller installation location. The controller will generate heat during
operation. If good heat dissipation conditions are not obtained, it may cause malfunction and fire.
7. Do not install the controller in a humid environment. If it must be installed, please do a good job of moisture-proof and waterproof
treatment.
8. Keep children away from the photovoltaic system.
1.
It is recommended to install the product indoors to avoid
direct sunlight, if it must be installed outdoors,Please take
measures to prevent rain.
2. This controller is only suitable for solar panels. Cannot be
used for diesel power generation, city power, windPower
generation and other charging control, otherwise it will
cause damage to the controller.
3. Please ensure that the controller is well ventilated and cannot
be installed in a completely sealed environment
