16
You selected IC7800 addr.6AH
and 19200 Bd. Press
SET
to write
to the memory, then press
EXIT
to
go back to the SETTINGS
possibilities.
“
SET OTHER ADDRESS
” means
that you must add here a new type
of ICOM TCVR which is not
defined in the table (its address
plus bitrate in Bd) to allow
communications with it.
Press
ANTENNA SETTINGS
. First
select
ANTENNA SWITCH
(No
switch, Standard). Use left or right
arrows. If you select some switch,
10 ports for different antennas
displays. Generally all of antennas
are allowed in every band (green
squares). To disable some square
select port (up/down), touch
SET
for antenna name and then select
band (left/right). Press
SET
.
Four types of antennas for four
different bands were disabled.
Black square means disabled
combination.
Press
EXIT
to go back to
SETTINGS
menu
BCD code (4 bits) is used for automatic antenna and BPF switching (see Antenna/BPF
connector on the Control panel (rear side of the PA). See section 7.9 for Control and
ANT/BPF connectors pin-out.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
