07
07
1
2
3
4
5
6
SMART WIFI SETUP
SMART WIFI INTERFACE WORK FLOW
REMOTE PAIRING
PROCEDURES FOR PAIRING REMOTE RECEIVER AND TRANSMITTER
These procedures apply if:
•
The remote is not functioning properly, and you simply want to reset a fan-remote
communication, or
•
You are replacing with a new receiver, or
•
You have 2 or more ceiling fans of the same model in one or nearby location
and you wish to be able to control with one Transmitter.
Pairing process as below:.
Within 30 seconds after restoring power to the fan, press and hold the
and
at same time for 3 seconds; the fan will beep twice, this indicates
pa
i
ring process has been completed.
Important Note: The pa
i
ring process must be completed within 30
seconds, otherwise the pairing will fail.
23
24
WIFI CONFIG
1. Initial Setup
When the Ceiling Fan is powered on, press and
hold the and on the Transmitter
for 3 seconds to configure Wi-Fi; the fan will
beep twice, indicating that the device has entered
Wi-Fi pairing mode. In order to control the Ceiling
Fan, follow the steps in the Quick Start Guide.
2. Pre-Connected Network
If any pre-connected WIFI network is found, the
Ceiling Fan will connect automatically and the
Ceiling Fan status in the NOMA iQ app will be
updated.
3. No Pre-Connected Network
If no pre-connected WiFi network is found, make
sure the Ceiling Fan is in pairing mode and follow
the Quick Start Guide to connect. Once connected,
the Ceiling Fan status in the NOMA iQ app will be
updated.
4. NO Network Found
If no WiFi network is found after 5 minutes, the WiFi function will automatically
turn off.
5. Reset WiFi Connection/Pairing Mode
To reset your WiFi connect or to set the Ceiling Fan to Wi-Fi pairing mode,
press and hold the and on the Transmitter for 3 seconds
to configure Wi-Fi; the fan will beep twice, indicating that the device has
entered Wi-Fi pairing mode.
