7
Operation
• Wash carefully under a water jet, out of range of the machine, the kneading paddle.
• Wash the tank and its safety cover going after the following instructions.
• Follow the inverse sequence to assemble the washed parts.
SETTING UP THE MACHINE
• The machine is now ready to operate and the tank can be filled with the meat mixture to be kneaded.
• After checking that the safety cover is properly placed on the tank, the plug can be attached to the power
socket.
• With a minimum clockwise rotation on the central red button STOP the button will be automatically put (by
a spring) in its withdrawn position: by pushing the button AVANTI the paddle will start to rotate to obtain the
kneading of the meat mixture.
ATTENTION
If during the kneading operation the safety cover of the tank is raised the paddle is immediately stopped. To
restart the operation the cover must be closed again and the button AVANTI pushed again.
• During the working phase it is possible, to better distribute the meat mixture in the tank, to invert the paddle
rotation only at steps. To make this operation it is necessary first to stop the machine by pushing down the
STOP button, second to rotate a little the STOP button to put it in the withdrawn position and third to push
the button INDIETRO. The button INDIETRO gives only steps of inverse rotation and the paddle will be
stopped as the button will be released.
• At the end of the kneading operation proceed as follows to empty-out the tank:
- Push down the button STOP.
- Disconnect the plug from the socket.
- To release the tank turn the hand wheel for coming out the check pin from its housing.
- To facilitate the tank unloading it is possible to rotate it up to the horizontal position; the sense of rotation
is such to maintain on high the safety cover when open.
- Unload the tank by hand.
- Return back the tank in vertical position and reinsert the check pin in its housing with procedure inverse to
the one above described.
Maintenance
DISASSEMBLING AND CLEANING
IMPORTANT
For the washing operations of the removable parts use only water (possibly warm water) and neutral detergent
for pottery. For the washing operation of the tank it is possible to introduce water (possibly warm water) and/or
additional neutral detergent for pottery which will be easily eliminated by using the overturning system; if some
detergent for pottery was added remember to carefully wash (at the end) with pure water. For the cleaning of
the machine structure and of the safety cover use first a damp cloth and then a dry cloth. Do not utilize in any
