9
Installation
UNPACKING
Remove Packaging Materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using.
•
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also
be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your ice maker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your ice maker before using it. See the
“Interior cleaning” in the Cleaning and Maintenance section.
LOCATION REQUIREMENTS
•
To ensure proper ventilation for your ice maker, the front of the unit must be completely unobstructed. Allow
more than 4” clearance at rear, 0.6” at top and sides for proper air circulation. The installation should allow
the ice maker to be pulled forward for servicing if necessary.
SIDE VIEW
I
NSTALLATION CLEARANCES
:
TOP VIEW
TOP VIEW
Excessive Weight Hazard
Use two or more people to move and install icemaker.
Failure to do so can result in back or other injury.
