6
Operation
Maintenance
Open the water inlet, make sure the water line is under the overflow holes position.
Plug in the socket, switch on. Turn the thermostat dial to the max position, the red light is on, the element starts
working.
When the water is boiling, put the pasta in the basket and cook.
After cooking, turn the thermostat dial to the min position for next cooking cycle.
When not using, turn off the thermostat to the minimum position, switch off the power, unplug the unit.
Caution: the water must be over the elements.
Proper cleaning after each use
Open the water outlet, drain all of the chamber’s water, then clean using warm soapy water. After cleaning,
close the water outlet.
Do not immerse completely in water to clean.
The appliance is not to be cleaned with a water jet.
Installation
Remove the Pasta Cooker from its packaging and place the unit on a firm and level surface.
When this appliance is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative
finished, etc., it is recommended that they be made of non-combustible material, if not, they must be fitted with
a suitable non-combustible heat-insulating material, and that the closest attention be paid to fire prevention
regulations.
Once the Pasta Cooker has been placed in position by consulting International Standards and regulations.
Connect the water pipes, Make sure the water inlet, outlet and overflow are in correct position according to the
marks.
Open the overflow valve, close the outlet valve.
The Pasta Cooker is now ready to operate.
