9
Troubleshooting
The machine stops because of an overload:
If the motor is blocked (foreign body, something too hard), the excess current protection system (14), located
under the appliance will be triggered automatically and cut off the electrical power to the motor.
• Set the On / Off switch (13) to “0” position, disconnect the appliance.
• Correct the fault then press the excess current protection button (14).
• Press the On/Off switch (13) (position I).
If the problem persists, check the following points:
• Check that the grinding wheels do not touch each other.
• Check the state of wear of the grinding wheels (grinding too fine with worn grinding wheels can result in a
motor overload like this).
•
If there are no foreign bodies preventing the appliance from working, then check and replace the motor
starter relay then the capacitor.
Summary of Contents for 44116
Page 10: ...10 Figure Drawings...
Page 11: ...11 Figure Drawings...
Page 12: ...12 Parts Breakdown Model Santos 01PV 44116...
Page 15: ...15 Electrical Schematics Model Santos 01PV 44116...
