7
Installation
CHECKS ON DELIVERY
When you receive the package containing the machine, carefully check the packaging for signs of damage
during shipping. If the packaging shows signs of mishandling, impacts or dropping, report the damage to the
shipping agent within three days of the date of delivery indicated on the documents and draw up a detailed
report on any damage to the product.
DISPOSING OF PACKAGING
The packaging materials (cardboard box, plastic strap and polyurethane foam) can be disposed of as normal
domestic waste; there is no difficulty in disposing of them. If the machine is installed in a country in which
special regulations apply, dispose of the material in a regulatory manner.
POSITIONING
Place the product on a solid surface following the surface dimensions indicated in the technical specifications;
the surface must be smooth, non-slippery, dry, robust and solid and it must be placed at a height of 80 cm
above the ground. Furthermore, the cutter must be placed in an environment with a max. non-saline humidity
of 75% and a temperature b5°C and +35°C; and, in any case, in an environment which does not lead
to any machine malfunctions.
ELECTRICAL CONNECTION
The machine has a power cable with a cross section of 3x1.5 mm², a length of 2.5 m and a NEMA plug.
Connect the machine to a 120 or 230 Volt 60 Hz power supply. Check that the earth system functions perfectly
and make sure the connection is provided with a thermo-magnetic 0.03A circuit breaker. Also check that
the information on the machine’s nameplate matches the specifications given in the delivery and shipping
documents, and that both the master switch and cable are easily accessible while the machine is in use.
PRELIMINARY CHECK
Check the integrity and correct position of all the components of the cutter before any operation. Then check
the correct functioning of all its components. Proceed as follows:
1.
Press the ON button and the OFF button.
2. Verify that the machine stops if the tank-locking arm is rotated anti-clockwise.
3.
Verify that the revolution speed increases and decreases by rotating the SPEED knob clockwise and anti-
clockwise.
4.
Press the PULSE button with brief pulses.
