9
Maintenance
electroshock risks.
•
After cleaning, carefully dry all parts part of the cutter and put them back together again.
CLEANING THE LID, BLADE HOLDER AND TANK
Rotate the closing arm to remove the lid. You can now easily remove the blade holder and tank by pulling them
upwards. Once the parts have been removed, clean them with water and neutral detergents.
CAUTION! Carry out these operations with protective gloves on.
MAINTENANCE
CAUTION! Before servicing the product, disconnect its power plug from the mains to isolate the
product completely from the rest of the system.
POWER CABLE
Check the condition of the cable regularly and call the SERVICE CENTRE if it needs replacing.
BELT
The belt does not need adjusting; generally it needs to be replaced after 3/4 years, in that case, contact the
“SERVICE CENTRE”.
FEET
The feet may deteriorate or lose elasticity, thus reducing stability of the cutter. Replace them contacting the
“SERVICE CENTRE”.
KNIVES
Check the condition of the blade, after many sharpenings it must not reduce more than 5mm. For replacement,
contact the “ASSISTANCE CENTER”.
CAUTION! For any anomaly/malfunction, contact the “SERVICE CENTRE”, any operation carried out
by unauthorized personnel may compromise the correct functioning of the machine and invalidate the
warranty.
BLADE SHARPENING
CAUTION!! Blades need to be sharpened if you notice a reduction in cutting performance.
Proceed as follows:
1. Rotate the lever in a clockwise direction to the position in which you can remove the lid.
2. Remove the blade holder
3.
Take the sharpening stone provided, and while being very CAREFUL, pass it uniformly over the cutting side
of the blades towards the outside until the blade is sharpened.
