10
Operation
extinguish the pilot. If the fryer shuts down due to overheating, DO NOT re-light the pilot until the shortening
temperature is below 300° F (149°C). If an overheating situation persists, contact Omcan.
BEFORE FIRST USE
CLEANING
New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the
manufacturing process. Before any food preparation, thoroughly wash the protective oil from all surface parts
and the tank interior with hot soapy water to remove any film residue and dust or debris.
NOTICE Do not use chlorine or sulfate/sulfide cleaners.
• Wash any accessories shipped with unit.
• Rinse fryer and accessories thoroughly and drain the fryer.
• Wipe tank completely dry with a soft, clean cloth.
WARNING Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the
fryer.
WARNING Spilling hot frying compound can cause severe burns. Do not move the fryer without
draining all frying compound from the tank.
FILLING TANK WITH SHORTENING
NOTICE Solid shortening should NOT be used with PRO-FRYERS. Melting solid shortening will damage
the tank and void your warranty.
•
Close the drain valve.
•
Check the level of the fryer.
• Fill the fryer tank with liquid shortening.
•
Shortening level should be between the min and max lines in the fryer tank.
• Shortening will expand when heated. Do not fill the fryer tank past the MAX line.
•
Add fresh shortening as needed to maintain oil level.
Before Start-Up • Inspect hose(s) for evidence of excessive wear, cuts or cracks. If evident, replace
only with manufacturer’s original parts before operation.
LIGHTING THE PILOT
1. Open the door.
2.
Turn the thermostat OFF. The thermostat is located behind the door.
3.
Push the gas control valve knob and turn to OFF. Wait 5 minutes for unburned gas to vent.
4.
Push and turn gas control valve knob to the “L” in PILOT.
5. While still holding the knob in, light the pilot with a lit flame. Continue to depress the knob until pilot remains
lit when knob is released. If the pilot does not remain lit, repeat step 3 through 5.
6. Depress and turn gas control knob to ON.
