7
Operation
Maintenance
• Before first use, clean the inner sides and the shelves with a soft cloth and a mild cleaning agent.
Afterwards, dry the device thoroughly.
• Remove the water bowl from the device. The water bowl is installed inside the device and then fill the water
bowl with water.
•
Connect the device to a single grounded power socket.
• Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30°C-90°C / 86°F-194°F.
•
The temperature inside of the hot display can be read from the front display.
•
Put the foods in appropriate containers before placing them inside the hot display and shut it by using the
sliding door.
•
Some of the device parts become very hot, always use safety gloves when placing or removing foods.
•
The foods are kept warm at the temperature set by you previously.
•
In order to place or remove foods, you may open the door at rear side.
• Switch on the inner light when required using the light switch of the device.
•
Disconnect the device from the power socket when the device is not in use.
•
Before beginning with repair or cleaning, make sure the device has been disconnected from the power
socket and has cooled down.
•
Do not use any acid agents and make sure no water enters the device.
•
To protect yourself from the electric shock, never immerse the device, its cables or plug in water, or other
liquids.
•
Do not use any kind of pressure washer jet for cleaning the device.
CLEANING
•
The device should be cleaned regularly.
•
Clean the device from the inside and outside with a soft, damp cloth and a mild cleaning agent.
•
Clean the shelves and the housing with a soft, damp cloth and a mild cleaning agent.
• Clean the water bowl regularly. Calcifications on the water bowl may be removed with common agents or
Installation
sensitive.
• The device should never be placed on a flammable surface (such as table cloth, carpet, ect).
• You must not position the device near open fireplaces, electric ovens, arc furnaces/electric heaters or other
heat sources.
•
Position the device in such a way that the plug is easily accessible.
