8
Operation
Maintenance
Troubleshooting
PREPARING THE ICE CRUSHER FOR LONG-TERM STORAGE
• Turn off the machine, unplug the power cord, wipe off the water on the power cord, and gather the power
cord up.
•
Wipe the surface of the machine and the outer surface of the hopper, and open the handle upwards, which
is conducive to the internal moisture distribution.
•
Keep the machine in a safe place and keep it out of reach of children.
CLEANING OF INTERNAL AND EXTERNAL PARTS
Note: Unplug the power plug before performing any cleaning or maintenance procedures. Do not use
alcohol to clean the ice crusher, as this may cause plastic parts to crack.
EXTERIOR
Use a clean, soft cloth to wipe the outside of the ice machine at least once a week, and then use a damp cloth
moistened with a neutral detergent to remove grease or other impurities.
ICE TRAY (AFTER EACH USE)
Immerse the ice tray in a mixture of neutral detergent and water for at least 3 minutes, then rinse with water
and dry.
HOPPER (AFTER EACH USE)
Open the handle, allow it to dry naturally, and then close it after drying. There is a sharp blade inside, operate
with care.
Issues
Check items
Possible causes
Solutions
Does not work.
Power cord.
Did not plug in or damaged.
Plug in or replace the power cord.
Socket.
Socket is out of shape.
Change to another socket.
Motor.
Motor burnt.
Replace the motor.
Power supply.
Power switch damaged.
Replace the switch.
Low voltage or no power.
Contact power supply department.
Micro switch.
Micro switch damaged.
Replace the micro switch.
